نقد و بررسی :
Analog Output Module 6ES7135-6HD00-0BA1
Analog Output Module 6ES7135-6HD00-0BA1
SIMATIC ET 200SP, Analog output module, AQ 4XU/I Standard, suitable for BU type A0, A1, Color code CC00, Module diagnostics, 16 bit, +/-0.3%
SIEMENS |
General information
|
|
Product type designation |
AQ 4xU/I ST |
HW functional status |
From FS07 |
usable BaseUnits |
BU type A0, A1 |
Color code for module-specific color identification plate |
CC00 |
Product function |
|
● I&M data |
Yes; I&M0 to I&M3 |
● Output range scalable |
No |
Engineering with |
|
● STEP 7 TIA Portal configurable/integrated as of version |
V11 SP2 / V13 |
● STEP 7 configurable/integrated as of version |
V5.5 SP3 / – |
● PCS 7 configurable/integrated as of version |
V8.1 SP1 |
● PROFIBUS as of GSD version/GSD revision |
One GSD file each, Revision 3 and 5 and higher |
● PROFINET as of GSD version/GSD revision |
GSDML V2.3 |
Operating mode |
|
● Oversampling |
No |
● MSO |
No |
|
CiR – Configuration in RUN |
Reparameterization possible in RUN |
Yes |
Calibration possible in RUN |
No |
|
Supply voltage |
Rated value (DC) |
24 V |
permissible range, lower limit (DC) |
19.2 V |
permissible range, upper limit (DC) |
28.8 V |
Reverse polarity protection |
Yes |
|
Input current |
Current consumption, max. |
150 mA |
|
Power loss |
Power loss, typ. |
1.5 W |
|
Address area |
Address space per module |
● Address space per module, max. |
8 byte; + 1 byte for QI information |
|
Analog outputs |
Number of analog outputs |
4 |
Voltage output, short-circuit current, max. |
45 mA |
Cycle time (all channels), min. |
5 ms |
Analog output with oversampling |
No |
Output ranges, voltage
|
● 0 to 10 V |
Yes; 15 bit |
● 1 V to 5 V |
Yes; 13 bit |
● -5 V to +5 V |
Yes; 15 bit incl. sign |
● -10 V to +10 V |
Yes; 16 bit incl. sign |
Output ranges, current |
● 0 to 20 mA |
Yes; 15 bit |
● -20 mA to +20 mA |
Yes; 16 bit incl. sign |
● 4 mA to 20 mA |
Yes; 14 bit |
Connection of actuators |
● for voltage output two-wire connection |
Yes |
● for voltage output four-wire connection |
Yes |
● for current output two-wire connection |
Yes |
Load impedance (in rated range of output) |
● with voltage outputs, min. |
2 kΩ |
● with voltage outputs, capacitive load, max. |
1 µF |
● with current outputs, max. |
500 Ω |
● with current outputs, inductive load, max. |
1 mH |
Destruction limits against externally applied voltages and currents |
● Voltages at the outputs |
30 V |
Cable length |
|
● shielded, max. |
1 000 m; 200 m for voltage output |
|
|
Analog value generation for the outputs |
|
Integration and conversion time/resolution per channel |
|
● Resolution with overrange (bit including sign), max. |
16 bit |
Settling time |
|
● for resistive load |
0.1 ms |
● for capacitive load |
1 ms |
● for inductive load |
0.5 ms |
|
Errors/accuracies |
|
Linearity error (relative to output range), (+/-) |
0.03 % |
Temperature error (relative to output range), (+/-) |
0.005 %/K |
Crosstalk between the outputs, min. |
-50 dB |
Repeat accuracy in steady state at 25 °C (relative to output range), (+/-) |
0.05 % |
Operational error limit in overall temperature range
|
|
● Voltage, relative to output range, (+/-) |
0.5 % |
● Current, relative to output range, (+/-) |
0.5 % |
Basic error limit (operational limit at 25 °C) |
|
● Voltage, relative to output range, (+/-) |
0.3 % |
● Current, relative to output range, (+/-) |
0.3 % |
|
|
Isochronous mode |
|
Isochronous operation (application synchronized up to terminal) |
No |
|
Interrupts/diagnostics/status information |
|
Diagnostics function |
Yes |
Substitute values connectable |
Yes |
Alarms |
|
● Diagnostic alarm |
Yes |
Diagnostic messages
|
|
● Monitoring the supply voltage |
Yes |
● Wire-break |
Yes |
● Short-circuit |
Yes |
● Group error |
Yes |
● Overflow/underflow |
Yes |
Diagnostics indication LED |
|
● Monitoring of the supply voltage (PWR-LED) |
Yes; Green PWR LED |
● Channel status display |
Yes; Green LED |
● for channel diagnostics |
No |
● for module diagnostics |
Yes; green/red DIAG LED |
|
Potential separation |
|
Potential separation channels |
|
● between the channels |
|
● between the channels and backplane bus |
● between the channels and the power supply of the electronics |
|
Isolation |
|
Isolation tested with |
707 V DC (type test) |
|
Ambient conditions |
|
Ambient temperature during operation |
|
● horizontal installation, min. |
-30 °C |
● horizontal installation, max. |
60 °C; Observe derating
-30 °C |
● vertical installation, min. |
● vertical installation, max. |
50 °C; Observe derating |
Altitude during operation relating to sea level |
|
● Installation altitude above sea level, max. |
2 000 m; On request: Installation altitudes greater than 2 000 m |
|
Dimensions |
|
Width |
15 mm |
Height |
73 mm |
Depth |
58 mm |
|
Weights |
|
Weight, approx. last modified: |
31 g |
01/20/2020 |
Analog Output Module 6ES7135-6HD00-0BA1
-
0 تومان
منبع تغذیه و شارژر 24 ولت 5.8 آمپر مین ول با توان اندازه گیری شده 160 وات در خروجی محاسبه شده است. این محصول در زمان اتصال باتری در کانال اول خروجی جریان معادل 3.8 آمپر و در کانال دوم معادل 2 آمپر می باشد. منبع تغذیه PSC-160 با قابلیت UPS از سری منبع تغذیه های سری SECURITY می باشد. همچنین تجهیز مدار ورودی به اصلاح ضریب قدرت ACTIVE PFC،…
-
150,000 تومان
منبع تغذیه 12 ولت 5 امپر (S-60-12) با توان خروجی 60 وات تحویلی به مصرف کننده اندازه گیری شده است. این منبع تغذیه دارای ابعاد کوچکی می باشد همین امر باعث می شود فضای کمی را اشغال می کند. ولتاژ ورودی که در این منبع تغذیه قابل قبول است بین 110 ولت تا 220 ولت ac می باشد
-
800,000 تومان
منبع تغذیه 24 ولت 4 آمپر وی وی ( mdr-100 ) با توان و قدرت 100 وات می باشد .سوئیچینگ سری MDR - 100 جزء محصولات ریلی این شرکت به حساب می آیند.سری MDR – 100 قابلیت نصب بر روی ریل های استاندارد TS-35 / 7.5 یا TS-35 / 15 دارد.جنس بدنه این منبع تغذیه از پلاستیک مرغوبی سخته شده است و توانایی تحمل محیط های سخت و صنعتی را…
-
0 تومان
منبع تغذیه 12ولت 1.3 آمپر (RS-15-12) مین ول با توان و قدرت اندازه گیری شده در خروجی برابر 15 وات می باشد. منبع تغذیه سوئیچینگ 12 ولت مین ول سری RS-15 جزء محصولات کف خواب این شرکت است. راندمان در این منبع تغذیه 81.5% است که به خوبی پاسخگوی نیاز کاربر می باشد. تلفات در این منبع تغذیه کم بوده و در حالت بی باری به کمتر از 0.5 وات…
-
نمره 5.00 از 5
660,000 تومان
منبع تغذیه 24 ولت 2.5 آمپر مین ول در مجموع با 60 ولت در خروجی می باشد . سری MDR 60 در دسته محصولات ریلی این شرکت قرار می گیرند.این منبع تغذیه قابلیت نصب بر روی ریل های DIN TS-35/7.5 یا DIN TS-35/15 را دارد. با توجه به ابعاد کوچک در داخل کابین و یا بر روی ریل فضای کمی را اشغال می کند به همین دلیل به این سری،…
-
0 تومان
منبع تغذیه 5 ولت 3 آمپر مین ول با توان 30 وات واقعی و تحویلی به مصرف کننده ساخته شده است. این منبع تغذیه جزء محصولات ریلی شرکت مین ول محسوب می شود. پاور 5 ولت مین ول در دسته اقتصادی محصولات این شرکت تایوانی قرار می گیرد. راندمان این منبع تغذیه به عدد بالای 89% می رسد که در نوع خود بسیار خوب و کارآمد است. تلفات توان در…
Reviews
There are no reviews yet.