نقد و بررسی :
Analog Output Module 6ES7135-6HD00-0BA1
Analog Output Module 6ES7135-6HD00-0BA1
SIMATIC ET 200SP, Analog output module, AQ 4XU/I Standard, suitable for BU type A0, A1, Color code CC00, Module diagnostics, 16 bit, +/-0.3%
SIEMENS |
General information
|
|
Product type designation |
AQ 4xU/I ST |
HW functional status |
From FS07 |
usable BaseUnits |
BU type A0, A1 |
Color code for module-specific color identification plate |
CC00 |
Product function |
|
● I&M data |
Yes; I&M0 to I&M3 |
● Output range scalable |
No |
Engineering with |
|
● STEP 7 TIA Portal configurable/integrated as of version |
V11 SP2 / V13 |
● STEP 7 configurable/integrated as of version |
V5.5 SP3 / – |
● PCS 7 configurable/integrated as of version |
V8.1 SP1 |
● PROFIBUS as of GSD version/GSD revision |
One GSD file each, Revision 3 and 5 and higher |
● PROFINET as of GSD version/GSD revision |
GSDML V2.3 |
Operating mode |
|
● Oversampling |
No |
● MSO |
No |
|
CiR – Configuration in RUN |
Reparameterization possible in RUN |
Yes |
Calibration possible in RUN |
No |
|
Supply voltage |
Rated value (DC) |
24 V |
permissible range, lower limit (DC) |
19.2 V |
permissible range, upper limit (DC) |
28.8 V |
Reverse polarity protection |
Yes |
|
Input current |
Current consumption, max. |
150 mA |
|
Power loss |
Power loss, typ. |
1.5 W |
|
Address area |
Address space per module |
● Address space per module, max. |
8 byte; + 1 byte for QI information |
|
Analog outputs |
Number of analog outputs |
4 |
Voltage output, short-circuit current, max. |
45 mA |
Cycle time (all channels), min. |
5 ms |
Analog output with oversampling |
No |
Output ranges, voltage
|
● 0 to 10 V |
Yes; 15 bit |
● 1 V to 5 V |
Yes; 13 bit |
● -5 V to +5 V |
Yes; 15 bit incl. sign |
● -10 V to +10 V |
Yes; 16 bit incl. sign |
Output ranges, current |
● 0 to 20 mA |
Yes; 15 bit |
● -20 mA to +20 mA |
Yes; 16 bit incl. sign |
● 4 mA to 20 mA |
Yes; 14 bit |
Connection of actuators |
● for voltage output two-wire connection |
Yes |
● for voltage output four-wire connection |
Yes |
● for current output two-wire connection |
Yes |
Load impedance (in rated range of output) |
● with voltage outputs, min. |
2 kΩ |
● with voltage outputs, capacitive load, max. |
1 µF |
● with current outputs, max. |
500 Ω |
● with current outputs, inductive load, max. |
1 mH |
Destruction limits against externally applied voltages and currents |
● Voltages at the outputs |
30 V |
Cable length |
|
● shielded, max. |
1 000 m; 200 m for voltage output |
|
|
Analog value generation for the outputs |
|
Integration and conversion time/resolution per channel |
|
● Resolution with overrange (bit including sign), max. |
16 bit |
Settling time |
|
● for resistive load |
0.1 ms |
● for capacitive load |
1 ms |
● for inductive load |
0.5 ms |
|
Errors/accuracies |
|
Linearity error (relative to output range), (+/-) |
0.03 % |
Temperature error (relative to output range), (+/-) |
0.005 %/K |
Crosstalk between the outputs, min. |
-50 dB |
Repeat accuracy in steady state at 25 °C (relative to output range), (+/-) |
0.05 % |
Operational error limit in overall temperature range
|
|
● Voltage, relative to output range, (+/-) |
0.5 % |
● Current, relative to output range, (+/-) |
0.5 % |
Basic error limit (operational limit at 25 °C) |
|
● Voltage, relative to output range, (+/-) |
0.3 % |
● Current, relative to output range, (+/-) |
0.3 % |
|
|
Isochronous mode |
|
Isochronous operation (application synchronized up to terminal) |
No |
|
Interrupts/diagnostics/status information |
|
Diagnostics function |
Yes |
Substitute values connectable |
Yes |
Alarms |
|
● Diagnostic alarm |
Yes |
Diagnostic messages
|
|
● Monitoring the supply voltage |
Yes |
● Wire-break |
Yes |
● Short-circuit |
Yes |
● Group error |
Yes |
● Overflow/underflow |
Yes |
Diagnostics indication LED |
|
● Monitoring of the supply voltage (PWR-LED) |
Yes; Green PWR LED |
● Channel status display |
Yes; Green LED |
● for channel diagnostics |
No |
● for module diagnostics |
Yes; green/red DIAG LED |
|
Potential separation |
|
Potential separation channels |
|
● between the channels |
|
● between the channels and backplane bus |
● between the channels and the power supply of the electronics |
|
Isolation |
|
Isolation tested with |
707 V DC (type test) |
|
Ambient conditions |
|
Ambient temperature during operation |
|
● horizontal installation, min. |
-30 °C |
● horizontal installation, max. |
60 °C; Observe derating
-30 °C |
● vertical installation, min. |
● vertical installation, max. |
50 °C; Observe derating |
Altitude during operation relating to sea level |
|
● Installation altitude above sea level, max. |
2 000 m; On request: Installation altitudes greater than 2 000 m |
|
Dimensions |
|
Width |
15 mm |
Height |
73 mm |
Depth |
58 mm |
|
Weights |
|
Weight, approx. last modified: |
31 g |
01/20/2020 |
Analog Output Module 6ES7135-6HD00-0BA1
-
0 تومان
منبع تغذیه 48 ولت 42 آمپر مین ول سری 48 RSP 2000 با توان 2016 وات واقعی در خروجی اندازه گیری شده است. یک از قابلیت های برجسته ی این سری از منبع تغذیه ها مین ول امکان موازی کردن تا چهار دستگاه با یک دیگر است به طوری که بتوان در خروجی با همان ولتاژ 48 ولت، جریان را حداکثر تا 168 آمپر افزایش دارد.
-
نمره 5.00 از 5
0 تومان
منبع تغذیه 24 ولت 2.5 آمپر مین ول (HDR-60-24) با توان 60 وات واقعی و تحویلی به مصرف کننده ساخته شده است. این منبع تغذیه جزء محصولات ریلی شرکت مین ول محسوب می شود. پاور 24 ولت مین ول در دسته اقتصادی محصولات این شرکت قرار می گیرد. راندمان این منبع تغذیه به عدد بالای 90% می رسد که در نوع خود بسیار خوب و کارآمد است. تلفات توان در…
-
0 تومان
مبدل 24 به 24 ولت 2.1 آمپر مین ول (SD-50B-24) با توان 50.4 وات واقعی اندازه گیری و تحویل مصرف کننده قرار می گیرد. این منبع تغذیه DC به DC در دسته محصولات کف خواب شرکت مین ول قرار می گیرد. راندمان کاری در این مبدل DC به DC به 80 درصد می رسد که عدد بالا و قابل قبولی می باشد. محافظت در برابر اتصال کوتاه، اضافه بار، ولتاژ…
-
0 تومان
مبدل12 به 24 ولت 2.1 آمپر (SD-50A-24) مین ول با توان 50.4 وات واقعی در خروجی اندازه گیری شده است. این مبدل DC به DC جزء دسته منبع تغذیه های کف خواب شرکت مین ول می باشد. ولتاژ ورودی منبع تغذیه SD-50A دارای بازه ی ولتاژی از 9 ولت تا 18 ولت می باشد. بازدهی (راندمان) این کانورتر به عدد بالای 74 درصد می رسد. که پاسخگوی نیاز های مصرف…
-
29,850,000 تومان
پنل لمسی (اچ ام ای) 12.1 اینچ وینتک با رزولوشن 1024*768 ساخته شده است. HMI وینتک سری MT8121XE دارای صفحه نمایش از نوع IPS LCD همراه با نور پس زمینه LED می باشد. پردازنده به کار رفته در این پنل لمسی Cortex-A8 با فرکانس 1 گیگا هرتز و از نوع 32 بیتی می باشد. حافظه رم (RAM) در این HMI ، 256 MB می باشد. همچنین حافظه فلش (FLASH) در…
-
0 تومان
منبع تغذیه 24 ولت 1.5 آمپر مین ول با توان 36 وات در خروجی در اختیار کاربر قرار می گیرد.این سوئیچینگ (LRS-35-24) در دسته ی منبع تغذیه های کف خواب شرکت مین ول قرار می گیرد.راندمان یا بازدهی در این منبع تغذیه به عدد بالای 86 درصد می رسد. که بسیار کارآمد می باشد.تلفات در این منبع تغذیه بسیار کم بوده به طوری که در حالت بی باری به کمتر…
Reviews
There are no reviews yet.