نقد و بررسی :
Analog Output Module 6ES7135-6HD00-0BA1
Analog Output Module 6ES7135-6HD00-0BA1
SIMATIC ET 200SP, Analog output module, AQ 4XU/I Standard, suitable for BU type A0, A1, Color code CC00, Module diagnostics, 16 bit, +/-0.3%
SIEMENS |
General information
|
|
Product type designation |
AQ 4xU/I ST |
HW functional status |
From FS07 |
usable BaseUnits |
BU type A0, A1 |
Color code for module-specific color identification plate |
CC00 |
Product function |
|
● I&M data |
Yes; I&M0 to I&M3 |
● Output range scalable |
No |
Engineering with |
|
● STEP 7 TIA Portal configurable/integrated as of version |
V11 SP2 / V13 |
● STEP 7 configurable/integrated as of version |
V5.5 SP3 / – |
● PCS 7 configurable/integrated as of version |
V8.1 SP1 |
● PROFIBUS as of GSD version/GSD revision |
One GSD file each, Revision 3 and 5 and higher |
● PROFINET as of GSD version/GSD revision |
GSDML V2.3 |
Operating mode |
|
● Oversampling |
No |
● MSO |
No |
|
CiR – Configuration in RUN |
Reparameterization possible in RUN |
Yes |
Calibration possible in RUN |
No |
|
Supply voltage |
Rated value (DC) |
24 V |
permissible range, lower limit (DC) |
19.2 V |
permissible range, upper limit (DC) |
28.8 V |
Reverse polarity protection |
Yes |
|
Input current |
Current consumption, max. |
150 mA |
|
Power loss |
Power loss, typ. |
1.5 W |
|
Address area |
Address space per module |
● Address space per module, max. |
8 byte; + 1 byte for QI information |
|
Analog outputs |
Number of analog outputs |
4 |
Voltage output, short-circuit current, max. |
45 mA |
Cycle time (all channels), min. |
5 ms |
Analog output with oversampling |
No |
Output ranges, voltage
|
● 0 to 10 V |
Yes; 15 bit |
● 1 V to 5 V |
Yes; 13 bit |
● -5 V to +5 V |
Yes; 15 bit incl. sign |
● -10 V to +10 V |
Yes; 16 bit incl. sign |
Output ranges, current |
● 0 to 20 mA |
Yes; 15 bit |
● -20 mA to +20 mA |
Yes; 16 bit incl. sign |
● 4 mA to 20 mA |
Yes; 14 bit |
Connection of actuators |
● for voltage output two-wire connection |
Yes |
● for voltage output four-wire connection |
Yes |
● for current output two-wire connection |
Yes |
Load impedance (in rated range of output) |
● with voltage outputs, min. |
2 kΩ |
● with voltage outputs, capacitive load, max. |
1 µF |
● with current outputs, max. |
500 Ω |
● with current outputs, inductive load, max. |
1 mH |
Destruction limits against externally applied voltages and currents |
● Voltages at the outputs |
30 V |
Cable length |
|
● shielded, max. |
1 000 m; 200 m for voltage output |
|
|
Analog value generation for the outputs |
|
Integration and conversion time/resolution per channel |
|
● Resolution with overrange (bit including sign), max. |
16 bit |
Settling time |
|
● for resistive load |
0.1 ms |
● for capacitive load |
1 ms |
● for inductive load |
0.5 ms |
|
Errors/accuracies |
|
Linearity error (relative to output range), (+/-) |
0.03 % |
Temperature error (relative to output range), (+/-) |
0.005 %/K |
Crosstalk between the outputs, min. |
-50 dB |
Repeat accuracy in steady state at 25 °C (relative to output range), (+/-) |
0.05 % |
Operational error limit in overall temperature range
|
|
● Voltage, relative to output range, (+/-) |
0.5 % |
● Current, relative to output range, (+/-) |
0.5 % |
Basic error limit (operational limit at 25 °C) |
|
● Voltage, relative to output range, (+/-) |
0.3 % |
● Current, relative to output range, (+/-) |
0.3 % |
|
|
Isochronous mode |
|
Isochronous operation (application synchronized up to terminal) |
No |
|
Interrupts/diagnostics/status information |
|
Diagnostics function |
Yes |
Substitute values connectable |
Yes |
Alarms |
|
● Diagnostic alarm |
Yes |
Diagnostic messages
|
|
● Monitoring the supply voltage |
Yes |
● Wire-break |
Yes |
● Short-circuit |
Yes |
● Group error |
Yes |
● Overflow/underflow |
Yes |
Diagnostics indication LED |
|
● Monitoring of the supply voltage (PWR-LED) |
Yes; Green PWR LED |
● Channel status display |
Yes; Green LED |
● for channel diagnostics |
No |
● for module diagnostics |
Yes; green/red DIAG LED |
|
Potential separation |
|
Potential separation channels |
|
● between the channels |
|
● between the channels and backplane bus |
● between the channels and the power supply of the electronics |
|
Isolation |
|
Isolation tested with |
707 V DC (type test) |
|
Ambient conditions |
|
Ambient temperature during operation |
|
● horizontal installation, min. |
-30 °C |
● horizontal installation, max. |
60 °C; Observe derating
-30 °C |
● vertical installation, min. |
● vertical installation, max. |
50 °C; Observe derating |
Altitude during operation relating to sea level |
|
● Installation altitude above sea level, max. |
2 000 m; On request: Installation altitudes greater than 2 000 m |
|
Dimensions |
|
Width |
15 mm |
Height |
73 mm |
Depth |
58 mm |
|
Weights |
|
Weight, approx. last modified: |
31 g |
01/20/2020 |
Analog Output Module 6ES7135-6HD00-0BA1
-
0 تومان
منبع تغذیه 48 ولت 12.5 آمپر مین ول با توان و قدرت 600 وات واقعی اندازه گیری شده است. این منبع تغذیه سوئیچینگ در دسته محصولات کف خواب این شرکت تایوانی قرار می گیرد. راندمان در این منبع تغذیه به عدد بالای 88% می رسد که به راحتی پاسخگوی نیاز کار می باشد. از ویژگی های حفاظتی در این منبع تغذیه می توان به حفاظت در برابر اتصال كوتاه، اضافه…
-
250,000 تومان
منبع تغذیه 12 ولت 10 امپر (S-120-12) با توان خروجی 120 وات تحویلی به مصرف کننده اندازه گیری شده است. این منبع تغذیه دارای ابعاد کوچکی می باشد همین امر باعث می شود فضای کمی را اشغال می کند. ولتاژ ورودی که در این منبع تغذیه قابل قبول است بین 110 ولت تا 220 ولت ac می باشد
-
0 تومان
منبع تغذیه 12 ولت 2.1 آمپر (RS-25-12) مین ول با توان و قدرت اندازه گیری شده در خروجی برابر 25.2 وات می باشد. منبع تغذیه سوئیچینگ 12 ولت مین ول سری RS-25 جزء محصولات کف خواب این شرکت است. راندمان در این منبع تغذیه 81.5% است که به خوبی پاسخگوی نیاز کاربر می باشد. تلفات در این منبع تغذیه کم بوده و در حالت بی باری به کمتر از 0.5…
-
98,000 تومان
فیوز مینیاتوری تک فاز اشنایدر کاربرد فیوز مینیاتوری اشنایدر عمومی بوده و در مصارف چه خانگی و چه صنعتی مورد استفاده است . فیوز مینیاتوری تک فاز اشنایدر از رنج 6 آمپر تا 25 آمپر تولید و عرضه بازار میشود . به عبارت ساده میتوان گفت که کاربرد فیوز برای حفاظت از دستگاه مصرفی دربرابر اضافه جریانه .
-
18,090,000 تومان
اینورتر های شرکت QMA Electronics چین بر اساس موتور های گیربکسی طراحی شده و به صورت تخصصی بر روی آسانسور و بالابر پیاده سازی شده است .درایو کنترل دور موتور آسانسور qma کیوما چین که در صنعت آسانسور ایران نام شناخته شده ای می باشد. در انواع مختلف OPEN و CLOSE طراحی و ساخته شده است
-
0 تومان
کانورتر 24 ولت 6.3 آمپر مین ول با توان و قدرت 151.2 وات واقعی در خروجی اندازه گیری شده است. این مبدل DC به DC در دسته کانورتر های کف خواب این شرکت تایوانی قرار می گیرد. راندمان در این منبع تغذیه DC به DC تا عدد بالای 82 در صد می رسد که در صنعت بسیار کاربردی ست. محافظت در برابر اتصال کوتاه، اضافه بار، ولتاژ بالا و درجه…
Reviews
There are no reviews yet.