نقد و بررسی :
Analog Output Module 6ES7135-6HD00-0BA1
Analog Output Module 6ES7135-6HD00-0BA1
SIMATIC ET 200SP, Analog output module, AQ 4XU/I Standard, suitable for BU type A0, A1, Color code CC00, Module diagnostics, 16 bit, +/-0.3%
SIEMENS |
General information
|
|
Product type designation |
AQ 4xU/I ST |
HW functional status |
From FS07 |
usable BaseUnits |
BU type A0, A1 |
Color code for module-specific color identification plate |
CC00 |
Product function |
|
● I&M data |
Yes; I&M0 to I&M3 |
● Output range scalable |
No |
Engineering with |
|
● STEP 7 TIA Portal configurable/integrated as of version |
V11 SP2 / V13 |
● STEP 7 configurable/integrated as of version |
V5.5 SP3 / – |
● PCS 7 configurable/integrated as of version |
V8.1 SP1 |
● PROFIBUS as of GSD version/GSD revision |
One GSD file each, Revision 3 and 5 and higher |
● PROFINET as of GSD version/GSD revision |
GSDML V2.3 |
Operating mode |
|
● Oversampling |
No |
● MSO |
No |
|
CiR – Configuration in RUN |
Reparameterization possible in RUN |
Yes |
Calibration possible in RUN |
No |
|
Supply voltage |
Rated value (DC) |
24 V |
permissible range, lower limit (DC) |
19.2 V |
permissible range, upper limit (DC) |
28.8 V |
Reverse polarity protection |
Yes |
|
Input current |
Current consumption, max. |
150 mA |
|
Power loss |
Power loss, typ. |
1.5 W |
|
Address area |
Address space per module |
● Address space per module, max. |
8 byte; + 1 byte for QI information |
|
Analog outputs |
Number of analog outputs |
4 |
Voltage output, short-circuit current, max. |
45 mA |
Cycle time (all channels), min. |
5 ms |
Analog output with oversampling |
No |
Output ranges, voltage
|
● 0 to 10 V |
Yes; 15 bit |
● 1 V to 5 V |
Yes; 13 bit |
● -5 V to +5 V |
Yes; 15 bit incl. sign |
● -10 V to +10 V |
Yes; 16 bit incl. sign |
Output ranges, current |
● 0 to 20 mA |
Yes; 15 bit |
● -20 mA to +20 mA |
Yes; 16 bit incl. sign |
● 4 mA to 20 mA |
Yes; 14 bit |
Connection of actuators |
● for voltage output two-wire connection |
Yes |
● for voltage output four-wire connection |
Yes |
● for current output two-wire connection |
Yes |
Load impedance (in rated range of output) |
● with voltage outputs, min. |
2 kΩ |
● with voltage outputs, capacitive load, max. |
1 µF |
● with current outputs, max. |
500 Ω |
● with current outputs, inductive load, max. |
1 mH |
Destruction limits against externally applied voltages and currents |
● Voltages at the outputs |
30 V |
Cable length |
|
● shielded, max. |
1 000 m; 200 m for voltage output |
|
|
Analog value generation for the outputs |
|
Integration and conversion time/resolution per channel |
|
● Resolution with overrange (bit including sign), max. |
16 bit |
Settling time |
|
● for resistive load |
0.1 ms |
● for capacitive load |
1 ms |
● for inductive load |
0.5 ms |
|
Errors/accuracies |
|
Linearity error (relative to output range), (+/-) |
0.03 % |
Temperature error (relative to output range), (+/-) |
0.005 %/K |
Crosstalk between the outputs, min. |
-50 dB |
Repeat accuracy in steady state at 25 °C (relative to output range), (+/-) |
0.05 % |
Operational error limit in overall temperature range
|
|
● Voltage, relative to output range, (+/-) |
0.5 % |
● Current, relative to output range, (+/-) |
0.5 % |
Basic error limit (operational limit at 25 °C) |
|
● Voltage, relative to output range, (+/-) |
0.3 % |
● Current, relative to output range, (+/-) |
0.3 % |
|
|
Isochronous mode |
|
Isochronous operation (application synchronized up to terminal) |
No |
|
Interrupts/diagnostics/status information |
|
Diagnostics function |
Yes |
Substitute values connectable |
Yes |
Alarms |
|
● Diagnostic alarm |
Yes |
Diagnostic messages
|
|
● Monitoring the supply voltage |
Yes |
● Wire-break |
Yes |
● Short-circuit |
Yes |
● Group error |
Yes |
● Overflow/underflow |
Yes |
Diagnostics indication LED |
|
● Monitoring of the supply voltage (PWR-LED) |
Yes; Green PWR LED |
● Channel status display |
Yes; Green LED |
● for channel diagnostics |
No |
● for module diagnostics |
Yes; green/red DIAG LED |
|
Potential separation |
|
Potential separation channels |
|
● between the channels |
|
● between the channels and backplane bus |
● between the channels and the power supply of the electronics |
|
Isolation |
|
Isolation tested with |
707 V DC (type test) |
|
Ambient conditions |
|
Ambient temperature during operation |
|
● horizontal installation, min. |
-30 °C |
● horizontal installation, max. |
60 °C; Observe derating
-30 °C |
● vertical installation, min. |
● vertical installation, max. |
50 °C; Observe derating |
Altitude during operation relating to sea level |
|
● Installation altitude above sea level, max. |
2 000 m; On request: Installation altitudes greater than 2 000 m |
|
Dimensions |
|
Width |
15 mm |
Height |
73 mm |
Depth |
58 mm |
|
Weights |
|
Weight, approx. last modified: |
31 g |
01/20/2020 |
Analog Output Module 6ES7135-6HD00-0BA1
-
8,800,000 تومان
آی سی اِس شاپ ارائه دهنده اینورتر invt با ماهمراه باشید با معرفی مشخصات درایو 4 کیلووات سه فاز اینوت invt سری GD270 درایو تخصصی پمپ و فن 🔺 برند : اینوت invt 🔺 نوع محصول : اينورتر 4 کیلووات سه فاز 🔺 کد فنی اینورتر : GD270-004-4 🔺 سری اینورتر : اينورتر GD270
-
56,650,000 تومان
اینورتر (مبدل DC به AC) 220 ولت مین ول با توان 3000 وات در خروجی اندازه گیری شده است. خروجی این اینورتر به صورت کاملا سینوسی و دقیق با ضریب خطا بسیار کم (THD < 0.3%) می باشد. توانایی تحمل سرج لحظه ای در این مبدل (مبدل DC به AC 3000 وات) در زمان جریان کشی اولیه تا 6000 وات می رسد. همچنین راندمان در این محصول به عدد بالای…
-
نمره 5.00 از 5
2,288,000 تومان
مبدل 48 به 24 ولت 4.2 آمپر (SD-100C-24) مین ول با توان و قدرت 100.8 وات در خروجی اندازه گیری شده است. این مبدل DC به DC در دسته منبع تغذیه های کف خواب شرکت مین ول قرار می گیرد. راندمان این منبع تغذیه تا 81 در صد افزایش پیدا می کند که این مقدار پاسخگو نیاز کاربر می باشد. محافظت در برابر اتصال کوتاه، اضافه بار، ولتاژ بالا و…
-
تماس بگیرید
SIMATIC ET 200SP, Analog input module, AI 4xRTD/TC High Feature, suitable for BU type A0, A1, Color code CC00, channel diagnostics, 16 bit, +/-0.1%, 2-/3-/4-wire
-
35,500,000 تومان
پنل لمسی 15 اینچ وینتک (WEINTEK HMI) با رزولوشن 1024*768 ساخته شده است. HMI وینتک سری MT8150XE دارای صفحه نمایش از نوع TFT LCD همراه با نور پس زمینه LED می باشد. بدنه ی این HMI (پنل لمسی) به صورت باریک (Slim Design) طراحی شده است. پردازنده به کار رفته در این پنل لمسی Cortex-A8 با فرکانس 1 گیگا هرتز و از نوع 32 بیتی می باشد. حافظه رم (RAM)…
-
14,520,000 تومان
شارژر 28.8 ولت 21 آمپر مین ول با توان اندازه گیری شده 600 وات در خروجی محاسبه شده است. اندمان در این شارژر به 87% می رسد که به راحتی پاسخگوی نیاز کاربران است. از ویژگی های این شارژر می توان به شارژ سه مرحله ای دارای مدار اصلاح ضریب قدرت PFC اشاره کرد
Reviews
There are no reviews yet.