نقد و بررسی :
Analog Output Module 6ES7135-6HD00-0BA1
Analog Output Module 6ES7135-6HD00-0BA1
SIMATIC ET 200SP, Analog output module, AQ 4XU/I Standard, suitable for BU type A0, A1, Color code CC00, Module diagnostics, 16 bit, +/-0.3%
SIEMENS |
General information
|
|
Product type designation |
AQ 4xU/I ST |
HW functional status |
From FS07 |
usable BaseUnits |
BU type A0, A1 |
Color code for module-specific color identification plate |
CC00 |
Product function |
|
● I&M data |
Yes; I&M0 to I&M3 |
● Output range scalable |
No |
Engineering with |
|
● STEP 7 TIA Portal configurable/integrated as of version |
V11 SP2 / V13 |
● STEP 7 configurable/integrated as of version |
V5.5 SP3 / – |
● PCS 7 configurable/integrated as of version |
V8.1 SP1 |
● PROFIBUS as of GSD version/GSD revision |
One GSD file each, Revision 3 and 5 and higher |
● PROFINET as of GSD version/GSD revision |
GSDML V2.3 |
Operating mode |
|
● Oversampling |
No |
● MSO |
No |
|
CiR – Configuration in RUN |
Reparameterization possible in RUN |
Yes |
Calibration possible in RUN |
No |
|
Supply voltage |
Rated value (DC) |
24 V |
permissible range, lower limit (DC) |
19.2 V |
permissible range, upper limit (DC) |
28.8 V |
Reverse polarity protection |
Yes |
|
Input current |
Current consumption, max. |
150 mA |
|
Power loss |
Power loss, typ. |
1.5 W |
|
Address area |
Address space per module |
● Address space per module, max. |
8 byte; + 1 byte for QI information |
|
Analog outputs |
Number of analog outputs |
4 |
Voltage output, short-circuit current, max. |
45 mA |
Cycle time (all channels), min. |
5 ms |
Analog output with oversampling |
No |
Output ranges, voltage
|
● 0 to 10 V |
Yes; 15 bit |
● 1 V to 5 V |
Yes; 13 bit |
● -5 V to +5 V |
Yes; 15 bit incl. sign |
● -10 V to +10 V |
Yes; 16 bit incl. sign |
Output ranges, current |
● 0 to 20 mA |
Yes; 15 bit |
● -20 mA to +20 mA |
Yes; 16 bit incl. sign |
● 4 mA to 20 mA |
Yes; 14 bit |
Connection of actuators |
● for voltage output two-wire connection |
Yes |
● for voltage output four-wire connection |
Yes |
● for current output two-wire connection |
Yes |
Load impedance (in rated range of output) |
● with voltage outputs, min. |
2 kΩ |
● with voltage outputs, capacitive load, max. |
1 µF |
● with current outputs, max. |
500 Ω |
● with current outputs, inductive load, max. |
1 mH |
Destruction limits against externally applied voltages and currents |
● Voltages at the outputs |
30 V |
Cable length |
|
● shielded, max. |
1 000 m; 200 m for voltage output |
|
|
Analog value generation for the outputs |
|
Integration and conversion time/resolution per channel |
|
● Resolution with overrange (bit including sign), max. |
16 bit |
Settling time |
|
● for resistive load |
0.1 ms |
● for capacitive load |
1 ms |
● for inductive load |
0.5 ms |
|
Errors/accuracies |
|
Linearity error (relative to output range), (+/-) |
0.03 % |
Temperature error (relative to output range), (+/-) |
0.005 %/K |
Crosstalk between the outputs, min. |
-50 dB |
Repeat accuracy in steady state at 25 °C (relative to output range), (+/-) |
0.05 % |
Operational error limit in overall temperature range
|
|
● Voltage, relative to output range, (+/-) |
0.5 % |
● Current, relative to output range, (+/-) |
0.5 % |
Basic error limit (operational limit at 25 °C) |
|
● Voltage, relative to output range, (+/-) |
0.3 % |
● Current, relative to output range, (+/-) |
0.3 % |
|
|
Isochronous mode |
|
Isochronous operation (application synchronized up to terminal) |
No |
|
Interrupts/diagnostics/status information |
|
Diagnostics function |
Yes |
Substitute values connectable |
Yes |
Alarms |
|
● Diagnostic alarm |
Yes |
Diagnostic messages
|
|
● Monitoring the supply voltage |
Yes |
● Wire-break |
Yes |
● Short-circuit |
Yes |
● Group error |
Yes |
● Overflow/underflow |
Yes |
Diagnostics indication LED |
|
● Monitoring of the supply voltage (PWR-LED) |
Yes; Green PWR LED |
● Channel status display |
Yes; Green LED |
● for channel diagnostics |
No |
● for module diagnostics |
Yes; green/red DIAG LED |
|
Potential separation |
|
Potential separation channels |
|
● between the channels |
|
● between the channels and backplane bus |
● between the channels and the power supply of the electronics |
|
Isolation |
|
Isolation tested with |
707 V DC (type test) |
|
Ambient conditions |
|
Ambient temperature during operation |
|
● horizontal installation, min. |
-30 °C |
● horizontal installation, max. |
60 °C; Observe derating
-30 °C |
● vertical installation, min. |
● vertical installation, max. |
50 °C; Observe derating |
Altitude during operation relating to sea level |
|
● Installation altitude above sea level, max. |
2 000 m; On request: Installation altitudes greater than 2 000 m |
|
Dimensions |
|
Width |
15 mm |
Height |
73 mm |
Depth |
58 mm |
|
Weights |
|
Weight, approx. last modified: |
31 g |
01/20/2020 |
Analog Output Module 6ES7135-6HD00-0BA1
-
150,000 تومان
منبع تغذیه 12 ولت 5 امپر (S-60-12) با توان خروجی 60 وات تحویلی به مصرف کننده اندازه گیری شده است. این منبع تغذیه دارای ابعاد کوچکی می باشد همین امر باعث می شود فضای کمی را اشغال می کند. ولتاژ ورودی که در این منبع تغذیه قابل قبول است بین 110 ولت تا 220 ولت ac می باشد
-
2,625,000 تومان
منبع تغذیه و شارژر 24 ولت 3.5 آمپر مین ول با توان اندازه گیری شده 100.7 وات در خروجی محاسبه شده است. این محصول در زمان اتصال باتری در کانال اول خروجی جریان معادل 2.4 آمپر و در کانال دوم معادل 1.25 آمپر می باشد. منبع تغذیه PSC-100 با قابلیت UPS از سری منبع تغذیه های سری SECURITY میباشد. راندمان در این شارژر به 88% می رسد که به راحتی…
-
تماس بگیرید
◀️ نوع محصول : سنسور امرن / القایی / مجاورتی ◀️ قطر سنسور : استوانه ای قطر 12 ◀️ خروجی سنسور : PNP NO
-
1,216,000 تومان
منبع تغذیه 12 ولت 17 آمپر مین ول (LRS-200-12) با توان و قدرت 204 وات در خروجی انداره گیری شده است. سوئیچینگ مین ول سری LRS-200-12 جزء درسته کف خواب محصولات شرکت مین ول محسوب می شود. این منبع تغذیه توانای تحمل ولتاژ ورودی تا 300 را تا 5ثانیه دارد. راندمان در این منبع تغذیه تا 87.5% اندازه گیری شده است که بسیار بالا و کاربردی می باشد. تلفات در…
-
8,800,000 تومان
آی سی اِس شاپ ارائه دهنده اینورتر invt با ماهمراه باشید با معرفی مشخصات درایو 4 کیلووات سه فاز اینوت invt سری GD270 درایو تخصصی پمپ و فن 🔺 برند : اینوت invt 🔺 نوع محصول : اينورتر 4 کیلووات سه فاز 🔺 کد فنی اینورتر : GD270-004-4 🔺 سری اینورتر : اينورتر GD270
-
450,000 تومان
منبع تغذیه 24 ولت 1 آمپر وی وی (MDR-20-24) در مجموع با 20 وات در خروجی می باشد . این منبع تغذیه قابلیت نصب بر روی ریل های DIN TS-35/7.5 یا DIN TS-35/15 را دارد.این پاور سوئیچینگ دارای تست صد در صد سلامت می باشد.
Reviews
There are no reviews yet.